EKSMA Optics uses cookies to give you the best shopping experience. If you continue to use our services, we will assume that you agree to the use of such cookies.

Understand
Your cart
0
There are no items in your cart.
Add items to your cart and request an official quote or order online
Your cart
0
Products categories
Login/Register
There are no items in your cart.
Add items to your cart and request an official quote or order online

EKSMA Optics uses cookies to give you the best shopping experience. If you continue to use our services, we will assume that you agree to the use of such cookies.

Understand
arrow--left
Go back

Power Supplies

Power Supplies

During operation current consumption will vary depending upon how the controller is being used. Before shipment, controllers are calibrated to the rated current of the motors they are to be used with.

from 40 $
delivery Estimated delivery time: 5 - 6 days
Products
Brochures
Description
Code Voltage Current Dimensions Weight Connector type Price Delivery Add to cart
PS24-2.5-4 24 V 2.5 A 125x50x31.5 mm 0.31 kg KPPX-4P 81 $ Request
PS12-1.5-4 12 V 1.5 A 98.5x55x31.5 mm 0.2 kg 2.1/5.5 40 $ Request
PS12-2.5-4 12 V 2.5 A 98.5x55x31.5 mm 0.25 kg 2.1/5.5 61 $ Request
PS36-4.4-4 36 V 3.34 A 167x65x37 mm 0.64 kg KPPX-4P 216 $ Request
Power Supplies for Controllers
318.3 kB
download PDF

Current requirements for stepper motor controller power supplies:

During operation current consumption will vary depending upon how the controller is being used. Before shipment, controllers are calibrated to the rated current of the motors they are to be used with. If you do not specify a motor, the controllers will be calibrated to a factory default value. Due to Pulse Width Modulation (PWM) controllers usually consume less current than the rated current of motors. However, to avoid problems during worst case scenarios, we recommend selecting a power supply with a max current not less than the rated current of motors that will be connected to the controller. In case of multi-axis controllers you will need to sum the current of all controllers connected to the power supply.

 

Requirements for stepper motor controllers power supply voltage:

Stepper motor controllers are a “chopper drive” type. This means that in the initial phase of the motor step controller will apply significantly higher voltage to motor winding than will occur in other drive types. This method allows stepper motors to be driven with higher torque at higher speeds. It should also be noted that stepper motor parasitic resonant effect behavior (“bad” frequencies position, for example) depends on supply voltage. Minimal allowable DC voltage of our stepper motor controllers is 12V and maximum is 36V.